Closed Cell Spray Foam Removal in Bridgwater is the controlled stripping of cured polyurethane foam from roof timbers, lofts and cavity walls. We handle homes across Bridgwater and Somerset where surveyors have flagged spray foam insulation, where mortgage lenders have refused, or where trapped moisture is rotting timber. Our team uses industrial vacuum extraction units and air scrubbers to take the foam out without spreading dust through your house. Most lofts are cleared in a single day.
Closed Cell Spray Foam Removal in Bridgwater means cutting, prizing and vacuuming out cured polyurethane foam that has bonded to roof timbers, rafters and felt. Closed cell spray foam sets rock hard, so it cannot be peeled away by hand. We cut it into manageable sections with reciprocating saws and oscillating multi-tools, then feed the waste into an industrial vacuum extraction unit so dust and foam fragments never reach your living space. A boroscope inspection camera lets us check the condition of the timber underneath before we finish.
Most jobs we see in Bridgwater start with a mortgage valuation. A surveyor flags spray foam insulation, the lender refuses to proceed, and the homeowner needs closed cell foam extraction Bridgwater fast. Older terraces around Eastover and Hamp are the usual suspects, because foam was sprayed directly onto roof timber with no vapour barrier. If you need closed cell spray foam removal for mortgage Bridgwater, we can usually survey within 24 hours and clear a standard loft in one working day.
Every Bridgwater job includes the survey, containment, extraction, timber inspection, waste disposal and a written handover report. Additional work such as timber treatment or replacement is quoted separately after the survey, so you always know the full cost before we start.
We inspect the roof space with a boroscope inspection camera and take moisture meter readings on the timbers. You get a written fixed price the same day, with no obligation. Surveys across Bridgwater are free and usually booked within 24 hours.
Protective sheeting, sealed loft hatches, air scrubbers and negative air machines go in before any cutting starts. That keeps foam dust out of your living space. Setup takes around 45 minutes on a typical Bridgwater terrace.
Technicians cut the closed cell foam into sections with reciprocating saws and oscillating multi-tools, then vacuum it into an industrial vacuum extraction unit. A standard 30 square metre loft takes four to six hours to clear completely.
Every rafter and batten is checked for rot, damp and insect damage once the foam is gone. Affected timber is treated or replaced. We photograph the whole structure so you have evidence for lenders, surveyors or building control.
All foam waste leaves the property sealed and goes to licensed disposal. You receive disposal documentation on request. Nothing is fly-tipped or left on site, and the loft is vacuumed clean before we finish.
You get a dated report with before and after photographs, moisture readings and a summary of the roof structure. It is written for lenders and surveyors, and it is the document most Bridgwater homeowners need to get their mortgage moving again.
We inspect the loft with a boroscope inspection camera and take moisture meter readings on the roof timbers. You get a written fixed price the same day, covering labour, waste removal and disposal. Surveys across Bridgwater and Somerset are free, and we can usually attend within 24 hours of your call.
Before any cutting starts, we lay protective sheeting, seal the loft hatch and position an air scrubber and negative air machine. That keeps dust and foam particles out of your bedrooms. The setup takes around 45 minutes on a typical Bridgwater terrace.
Technicians in PPE disposable coveralls and respirator filters cut the closed cell spray foam into sections with reciprocating saws and oscillating multi-tools. The waste goes straight into an industrial vacuum extraction unit. A standard 30 square metre loft takes four to six hours to clear.
With the foam gone, we check every rafter and batten for rot, damp or insect damage. Any affected timber is treated or replaced. We photograph the whole roof structure so you have evidence for your lender, surveyor or building control officer.
We vacuum the loft, wipe down surfaces and remove all waste for licensed disposal. You get a handover pack with before and after photographs, moisture readings and a workmanship warranty. Most Bridgwater jobs are finished and cleaned up within a single day.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Captures foam fragments and fine dust at the point of cutting, so nothing escapes into the rest of the house. Every Bridgwater job runs at least one unit.
Keeps the loft under negative pressure and filters airborne particles. Essential when the property is occupied, especially where children or asthma sufferers live.
Cuts cured closed cell foam into manageable sections without damaging the rafters underneath. Different blade types are used for foam and for timber.
Lets us see behind foam, into eaves and along rafters before and after extraction. We use it to confirm the timber is sound and no foam is left hidden.
Reads timber moisture content and spots cold spots or damp patches invisible to the eye. Readings above 20 percent trigger a closer inspection and treatment.
Freezes and cracks foam off delicate or historic timber without abrasive damage. Used on older Bridgwater roof structures where saws would be too aggressive.
Applies controlled heat to soften the bond between foam and timber. Slower than cutting, but gentler on rafters that are already weakened.
A three-bedroom terrace in Eastover had closed cell foam sprayed across the entire roof slope. The buyer's lender refused the mortgage, and the sale had already stalled once. Moisture readings on the rafters were 23 percent.
We cleared the foam in one day, treated two affected rafters and issued a report with photographs and new readings of 15 percent. The lender lifted its objection and the sale completed three weeks later.
A 1930s semi in Wembdon had foam blocking the loft ventilation for over a decade. The owner noticed a musty smell every winter and mould on the ceiling below. A thermal imaging camera showed cold spots across the roof slope.
Extraction took five hours with air scrubbers running throughout. The smell cleared within a week, and follow-up moisture readings dropped from 21 to 13 percent. The owner reinsulated with mineral wool and a breathable membrane.
A detached property on North Petherton Road had foam injected into the cavity walls, causing damp patches on the internal walls. The owner was struggling to get home insurance and had been quoted for a full cavity rebuild.
We removed the foam through drilled access points using an industrial vacuum extraction unit, then confirmed the cavity was clear. The damp patches dried out over six weeks, and the owner obtained standard cover without a specialist premium.
Closed cell foam causes a predictable set of problems in Bridgwater homes. Here are the ones we see most often, and how we put them right.
Ask a pro →We remove the foam, inspect the timbers and produce a dated report with photographs and moisture readings. Bridgwater surveyors accept our documentation, and most lenders lift their objection once they see the roof is sound.
We strip the foam, dry the timbers and treat any early decay. A moisture meter reading above 20 percent triggers a closer look. Catching rot early keeps the repair to a single rafter rather than a whole roof.
Once the foam is out, air moves again through the eaves. We check the breathable membrane and advise on ventilation before you reinsulate. Most customers notice the smell gone within a week.
Our removal report gives insurers the evidence they need: the foam is gone, the timbers are sound and the roof is ventilated. Several Bridgwater customers have had standard cover reinstated after sending our documentation.
Most Bridgwater lofts cost between 1,200 and 2,800 pounds to clear, with larger roofs or difficult access reaching 3,500 pounds. The price covers the survey, containment, cutting, extraction, waste disposal and your handover report. Closed cell foam is denser than open cell, so it takes longer to cut out, which is the main reason it costs more. We give you a fixed written price after the free survey, so there are no surprises on the day.
Yes. We cut the foam off rafters, battens and trusses with reciprocating saws and oscillating multi-tools, then vacuum the waste away. Closed cell foam bonds hard to timber, so the work has to be done carefully to avoid gouging the wood. After extraction we inspect every timber with a boroscope inspection camera and moisture meter. If we find rot, we treat or replace the affected sections before we finish.
Yes, considerably harder. Closed cell spray foam sets to roughly 30 to 40 kilograms per cubic metre, while open cell is closer to 8. That density means it cannot be scraped off; it has to be cut into sections and extracted mechanically. A closed cell loft typically takes four to six hours to clear, against two to three hours for open cell. We carry different blades and vacuum heads for each type.
A standard 30 square metre Bridgwater loft takes four to six hours of extraction work, and most jobs are completed within a single day including clean-down. Larger roofs, multiple slopes or foam sprayed into cavity walls can run to two days. We confirm the expected duration at the survey, and you get a call if anything changes on site. Same-day slots are often available if you ring before 10am.
Spray Foam Removal near meIf you are searching for spray foam removal near me in Bridgwater, we cover the whole town and surrounding villages. The same crews who handle closed cell extraction also deal with mixed foam installations, so you get one team for the entire roof.Explore →
Same day Spray Foam RemovalLender deadlines and probate sales do not wait. Call before 10am and we can often have a crew in your Bridgwater loft the same afternoon. Same day spray foam removal uses the same containment, extraction and reporting process as a scheduled job.Explore →
24/7 Spray Foam RemovalOur phone line stays open around the clock for urgent spray foam problems. If foam is causing a leak, a smell or a collapsed ceiling, we can arrange an emergency attendance. Overnight and weekend call-outs are quoted at the standard rate, not a premium.Explore →
Residential Spray Foam RemovalMost of our Bridgwater work is residential: terraces in Eastover, semis in Wembdon and detached homes along Bath Road. We protect carpets, seal loft hatches and clean up fully before leaving. You get a home ready to sell, remortgage or insulate properly.Explore →
Commercial Spray Foam RemovalWe clear spray foam from commercial roofs, warehouses and agricultural buildings around Bridgwater and the Somerset levels. Work is scheduled around your operating hours, and we provide method statements and risk assessments for site managers. Waste is segregated and disposed of under licensed carriers.Explore →
Loft Spray Foam RemovalLoft spray foam removal is our most common job in Bridgwater. Foam sprayed between rafters traps moisture and blocks ventilation, which is why surveyors flag it. We strip the foam, check the timbers and leave the loft ready for breathable insulation that meets current standards.Explore →
Roof Spray Foam RemovalFoam sprayed directly onto the underside of roof tiles or felt is the hardest to reach. We work from inside the loft with long-reach tools and boroscope inspection cameras to clear it without disturbing the roof covering. That avoids the cost of scaffolding in most Bridgwater cases.Explore →
Attic Spray Foam RemovalAttic spaces in older Bridgwater properties often have foam packed into awkward corners and around chimney breasts. Our technicians use oscillating multi-tools and industrial vacuum extraction units to clear these tight spots. We then check for condensation and damp before signing the job off.Explore →We are CHAS accredited, fully insured and have four years of spray foam removal behind us. Surveys are free, prices are fixed, and most lofts are cleared in a single day. Call 0127 827 6038 and we will book you in, often within 24 hours.
Get a Free Survey 0127 827 6038 →Call 0127 827 6038 or email us and a technician will get back to you the same working day. We answer the phone from 8am to 6pm Monday to Friday, and our emergency line is staffed 24/7 for urgent foam problems. Free surveys across Bridgwater and the surrounding villages, usually booked within two working days.